2ÍâÉè¿ØÖÆÆ÷ CY7C63723C-SXC Cypress Semiconductor - enCoRe USB Combination Low-Speed USB & PS/2 Peripheral Controller
Features
• enCoRe™ USB - enhanced Component Reduction
¡ªInternal oscillator eliminates the need for an external crystal or resonator
¡ªInterface can auto-configure to operate as PS/2 or USB without the need for external components to switch between
modes (no GPIO pins needed to manage dual mode capability)
¡ªInternal 3.3V regulator for USB pull-up resistor
¡ªConfigurable GPIO for real-world interface without external components
• Flexible, cost-effective solution for applications that combine PS/2 and low-speed USB, such as mice, gamepads,
joysticks, and many others.
• USB Specification Compliance
¡ªConforms to USB Specification, Version 2.0
¡ªConforms to USB HID Specification, Version 1.1
¡ªSupports 1 Low-Speed USB device address and 3 data endpoints
¡ªIntegrated USB transceiver
¡ª3.3V regulated output for USB pull-up resistor
• 8-bit RISC microcontroller
¡ªHarvard architecture
¡ª6-MHz external ceramic resonator or internal clock mode
¡ª12-MHz internal CPU clock
¡ªInternal memory
¡ª256 bytes of RAM
¡ª8 Kbytes of EPROM
¡ªInterface can auto-configure to operate as PS/2 or USB
¡ªNo external components for switching between PS/2 and USB modes¡ªNo GPIO pins needed to manage dual mode capability
• I/O ports
¡ªUp to 16 versatile General Purpose I/O (GPIO) pins, individually configurable
¡ªHigh current drive on any GPIO pin: 50 mA/pin current sink
¡ªEach GPIO pin supports high-impedance inputs, internal pull-ups, open drain outputs or traditional CMOS outputs
¡ªMaskable interrupts on all I/O pins
• SPI serial communication block
¡ªMaster or slave operation
¡ª2 Mbit/s transfers
• Four 8-bit Input Capture registers
¡ªTwo registers each for two input pins
¡ªCapture timer setting with 5 prescaler settings
¡ªSeparate registers for rising and falling edge capture
¡ªSimplifies interface to RF inputs for wireless applications
• Internal low-power wake-up timer during suspend mode
¡ªPeriodic wake-up with no external components
• Optional 6-MHz internal oscillator mode
¡ªAllows fast start-up from suspend mode
• Watchdog Reset (WDR)
• Low-voltage Reset at 3.75V
• Internal brown-out reset for suspend mode
• Improved output drivers to reduce EMI
• Operating voltage from 4.0V to 5.5VDC
• Operating temperature from 0 to 70 degrees Celsius
• CY7C63723 available in 18-pin SOIC, 18-pin PDIP
• CY7C63743 available in 24-pin SOIC, 24-pin PDIP
• CY7C63722 available in DIE form
• Industry standard programmer support